Fixing HACCP wall and ceiling panels. How does that work?

Hygienic wall panels of Wonder Board, which meet the HACCP standards, can be mounted on any surface. However, should satisfy a number of conditions when the panels are installed as a wall or ceiling.

Mounting instructions Wonderboard

dry walls
The walls must be dry, not just for the view, but actually the moisture from the wall. Use a dryer construction, length of time of drying is situated on the humidity of the walls.
removing obstacles
Remove any obstructions so that the cleaning and installation is simple.
sanding walls
When flaking paint, rust or a coating layer
Clean existing wall
Remove grease, adhesive residues and contaminants. Use the appropriate cleaner. Rub with a cloth in the same direction.
Degreasing miracle board panel
Scoured the back (where the glue comes) with a cleaner, acetone or equivalent
Check the moisture in walls
Use a moisture meter
The surface is still wet, dry the entire space.
primer
The primer is intended to promote a good adhesion of the glue. Do you have smooth surfaces like tile or painting using the primer.

VIS_1282

Above is a summary of the detailed installation instruction leaflet. Please read carefully the detailed installation instructions before you start the project. To support the installation directory we have created a video installation to clarify the screen.

Connecting with 2-component glue

VIS_1249

The glue may be applied after treatment of the above-mentioned requirements, on the wall. The miracle board panels should after placing are connected to each other so that no dirt can get between or behind the panels. The compound can be done by:

  • connection Profiles
    • Wonderboard is used in sandwich panels which have a greater thickness.
      2-component adhesive
  • 2-component glue
    • This is what we recommend if applicable
Please note that concerns 2-component adhesive

In the application of the 2-component adhesive, it is of the utmost importance that, in the joint, and is not only placed there between. The cause is the use of an excessively thin area between the end of the panel and the adhesive tape. When the stripping of the joint with a knife, the adhesive will be too thin, so there is already at a small shrinkage of the plate, cracks occur in the 2-component adhesive.

In some cases, it is even advisable to apply a convex joint. We advise in areas where external temperature differences are important, for example, think of cold in hot environments.

wonderboard

After the two-component adhesive or connection profiles are used, the corners are finished with profiles to create dirt-proof walls. The space now meets all hygiene requirements and is ready for use. The hygienic walls can now do their work at: Butchers, bakeries, car washes, hospitals, chemical industry, kitchens, refrigerators and freezers, fish and food processing and sanitary areas.

Do you have any questions? Our staff are always there for you! Verkoop@milin.nl mail to or contact us at: 030 657 90 20

No reactions yet

Give you reaction

Your email address will not be published. Required fields are marked *